How To Start Your Nitro RC Car

hahahahaha unless …
hahahahaha unless ur running it rich fuel goes no where near the blow back pipe as the exhaust gases go through that pipe into the tank and pushes the nitro through the other fuel line feeding the carb , and i posted this last december and im still alive and kicking mate :).

you dont drink the …
you dont drink the fule you blow back into the tube dumb god people and there comments some times

dude tell your wife …
dude tell your wife and kids not 2 wonder y your dead in 2 weeks.

your stupid y the would u put your mouth on a tube were exhaust or fuel goes throw look on your fuel thing nd you'll see a skull do u think they put that on there 4 fun .

wrong again, when u …
wrong again, when u have radio interferes ur wheels won't spin at idle, because the servo is swapping around so ur car drive away

well you would but …
well you would but the comment said the wheels consistantly spin at idlenot about the car reving but good point

wrong wrong wrong, …
wrong wrong wrong, first thing to do is looking for possible radio interfereces

basically a rotor …
basically a rotor start gun is used on an engine that allready has the rotor start backplate put on which enables you to use the gun (similar to a drill) to easily turn the engine over with alot less hassle than the pull start

hey can sum1 …
hey can sum1 explain me how rotor gun works?

gas? It's called …
gas? It's called nitro fuel. And the type of fuel depends on the engine. Most people use 16% for smallblock engines (1/10th scale) and
20%/25% for bigblocks (1/8th scale)

how do u no what …
how do u no what kind of gas u need

1/8 is bigger which …
1/8 is bigger which are normally used in buggys, truggys and monsterstrucks which normally average about 30-50mph varying on the model u buy, 1/10 are smaller which are normally seen as a on road but 1/10 buggys and truggys are available the speeds vary from model you buy but they can do from 30 to 80mph depending on how deep pockets you have.

what are bigger 1/ …
what are bigger 1/10th or 1/8th nitro cars and which go faster?

This is normally …
This is normally because of the trim set to high on the controller just adjust it and it will idle nicely , if its a high idle just find the low speed needle and turn it anticlockwise 1/16 of a turn intill u see the idle drop or a air leak which could be from mamy parts of the engine (Bearings, Carbs , LSN or HSN etc) the best way to check for them is to just go to ur model shop as they will be able to do it in minuites.

Hope This Helps

Yes i see what you …
Yes i see what you mean , but the car had a nearly worn clutch which ment starting was a real pain so i thought i'd show people ways to start it if they are having trouble.

Hm, if you primed …
Hm, if you primed your engine correctly you wouldnt need to pull on the pull start or add any fuel into the carb.

my wheels go crazy …
my wheels go crazy it is a brand new car

This could be one …
This could be one of many things , ur throttle trim maybe set to high just adjust it back down turning it anti clockwise or ur idle maybe to lean which could be caused by a hole in the fuel lines or the idle needle just needs to be adjusted anti clockwise in 1/16's intill the wheels stop spining , but if the car cant idle without the wheels spining this most likely means ur clutch springs or shoes have worn.

Hope This Helps

I don't know maybe. …
I don't know maybe….

CuttingEdgeINT …
CuttingEdgeINT maybe your clutch is broken….

i just bought an rc …
i just bought an rc car. when i start the engine the wheels go mental, i have to stop the car. why is tis happening?? plz help

its called …
its called hydrolock. in the engine should be a little metal bit get that out pull it a few times fuel shoud come out and put it back in

it will get looser …
it will get looser after a few tanks as the engine is wearing down into a comfy position sort of, usally after 5-7 tanks it will get looser.

can any one help me …
can any one help me im new to nitro rc cars and my pull start is really stiff is their any way to losen it thx

my jato wont go …
my jato wont go into second either it wines all the way out in first hits a little pebble and then a sewer cap then it finalllly shifts into second

ohk ok do u would u …
ohk ok do u would u happen to no why my nitro car wont change into 2nd gear ? thanks